Reasons and solutions for the slow operation of the stacked screw sludge dewatering machine
Compared with the centrifugal dewatering machine, the stacked screw sludge dewatering machine can save energy by 85% under the same processing conditions and occupy only half of the floor space. The surface is clean, and the belt filter saves 95%. The screw stacking machine is especially suitable for processing the pressure oil sludge flocculation of food processing plants. The removal rate of sludge dewatering rate can reach more than 60%. In addition, in order to adapt to the seasonal changes in the water from the sewage treatment, the sludge dewatering machine of Huiming Environmental Protection Co., Ltd. adopts a detachable independent structure.
When the stack screw sludge dewatering machine is working, sometimes there will be slow problems, and it should be checked and eliminated in time. The common reasons are as follows:
1. The pneumatic diaphragm pump of the stacked screw sludge dehydrator fails to start.
2. Check whether the steam filter and lubrication device of the stacked screw sludge dewatering machine is working normally. If it is abnormal, it should be replaced in time.
3. Check if there are impurities or other objects at the bottom of the air valve blocking the air inlet of the valve.
4. Check whether the motion shaft is worn out, or the position is shifted and jammed. If there is, the position needs to be adjusted.
During the work of the screw sludge dewatering machine, if there is a sudden interruption, first immediately power off the screw sludge dewatering machine, and then check whether there is a mechanical failure, check which part is broken, and promptly The replacement parts eliminate all the causes of the parts, and then restart the test.
- Introduction to the use characteristics of sewage purification vehicles
- Precautions for operation of laminated sludge dewatering machine
- Selection standard of sludge dewatering machine
- The processing method of the fixed ring of the ring piece of the screw stacking machine
- How to adjust the high water content of the stacked screw sludge dewatering machine
- What does the settling time of the snail sludge dewatering machine depend on?
- Correct use of screw stacking machine
- What is the processing effect of the screw stacking machine?
- Precautions for the safe use of stacked screw sludge dewatering machine
- The difference between traditional septic tank cleaning and sewage suction purification truck cleaning
- What factors will cause the high water content of the snail stacking machine
- The advantages of the new screw stacking machine are gathered
- What to pay attention to when using the stacked screw sludge dewatering machine
- How to choose a suitable sludge dewatering machine
- The stacked screw sludge dewatering machine removes the larger particles in the mud 3mm
- Several aspects that need to be considered when choosing a model of sludge dewatering equipment
- What is the difference between a vehicle-mounted screw stacker and a filter press
- The environmental protection manufacturer tells you how to treat medical sewage
- Why does the mud drop after the screw stacker is dehydrated?
- Do you know how to maintain the belt sludge dewatering machine?