How to make the filter cloth deviation of belt sludge dewatering machine
The filter cloth of the belt sludge dewatering machine will inevitably be offset. This is because when the filter cloth is connected, it is inevitably loose, long and short, and there is a parallel error in the direction of the replacement roller. Then, the vacuum belt filter cloth runs.
1. Check to make sure the air source is turned on. See "Air Requirements" above. Check the air filter and clean it if necessary.
2. Check the limit switch lever. The lever should lightly touch the filter cloth. When the filter cloth is centered, its normal position is at an angle of 0 degrees to the vertical. If the contact angle is greater than or less than 16 degrees and the filter cloth continues to slide to one side, the following measures should be taken:
1) Stop the filter.
2) Push or pull the limit switch lever along the offset direction of the filter cloth by hand. The correction roller should start or continue to move. If this is not the case, you need to adjust the position of the lever.
3) If the cylinder is fully inflated and the correction roller still cannot be corrected, it means that the angle of the centering wheel can be further adjusted on the drive side bearing. At the same time, in the groove of the driving side rotating roller, the driving side roller bearing moves in the direction of the filter cloth stroke, so that the filter cloth is located in the middle of the filter. Hold the drive roller firmly and wait at least 15 minutes to check whether the filter cloth is in the middle position. Remember that when the filter cloth is in the center position, the cylinders on each side will not move. The limit switch lever forms a 0 degree angle with the vertical line of the filter cloth, just touch the filter cloth.
4) If the limit switch lever moves, the cylinder is not fully deployed, and the roller does not move, check whether the air pipe is loose or the air source is sufficient. If these are not problems, and the airbag does not respond to the movement of the rod, there may be a problem with the airbag or restriction control.
- Introduction to the use characteristics of sewage purification vehicles
- Precautions for operation of laminated sludge dewatering machine
- Selection standard of sludge dewatering machine
- The processing method of the fixed ring of the ring piece of the screw stacking machine
- How to adjust the high water content of the stacked screw sludge dewatering machine
- What does the settling time of the snail sludge dewatering machine depend on?
- Correct use of screw stacking machine
- What is the processing effect of the screw stacking machine?
- Precautions for the safe use of stacked screw sludge dewatering machine
- The difference between traditional septic tank cleaning and sewage suction purification truck cleaning
- The feeding of the screw stacker should be evenly distributed to avoid excessive work
- What is the effect of the screw stacking machine for the dewatering of urban domestic sewage?
- Precautions for the use of sludge dewatering machine
- Installation and debugging instructions for screw stacking machine
- Daily maintenance method of snail sludge dewatering machine get
- What should I do when the screw-type sludge dehydrator is abnormally interrupted?
- The development history of the sincere environmental sewage purification vehicle
- The operation of the stacked screw sludge dewatering machine is divided into two modes: manual mode
- Screw stacking machine solves the harm of domestic sewage to the environment
- The amount of PAM used in the treatment of sludge by the centrifugal dewatering machine