Home > news > The feeding of the screw stacker should be evenly distributed to avoid excessive work
The feeding of the screw stacker should be evenly distributed to avoid excessive work
- 2020-06-09-

The feeding of the screw stacker should be evenly distributed to avoid excessive work


The screw stacker should be cleared of debris before starting up. In fact, there should be no debris after the equipment is used up, especially in the screw shaft head, the equipment groove, the filter body, etc., and regular inspections should be done. , Metal is not allowed; check after turning on the machine, carefully observe whether the screw shaft rotates normally, whether the mixing tank mud is stable, whether the rotating parts are operating normally, and whether there are abnormal noises; the screw stacker must be set during operation Reasonable operation and shutdown time, neither too long nor too short, and complete the whole process according to requirements. The machine of the screw stacker works for about 6-8 minutes, and the outlet pipe has no water flowing out, and the power supply can be blocked; screw stacker When shutting down, first turn off the sludge feed pump, stop the sludge feeding, turn off the dosing pump, dosing system, stop dosing, empty the flocculation mixing tank, stop the flocculation stirring motor, wait until all the sludge is exhausted, and spray it manually. Drain the filter body for 5 minutes to rinse the equipment clean, and then turn off the power.